What is the reason why the gas stove flame does not turn on?
The reason why a gas stove flame does not turn on may be related to things like the gas stove's safety and thermocouple system or problems with the gas flame screw. In any case, by finding the right cause, you can solve this problem.
Gas stove is one of the most used household appliances that we use for our daily food preparation and for this reason, it is very likely to have some problems at times. One of the problems that you may face when using this appliance is extinguishing the flames that can leave the cooking task half-finished. Below, we will examine why the gas stove flame does not turn on and resolve this issue.
The reason why the gas stove flame does not ignite
1. A thermocouple is one of the reasons why a gas stove is turned off
The safety system on new gas hobs cuts off the gas and extinguishes the burner flame if the gas hob deviates from normal operation. This will prevent saturation of the kitchen space with gas, for whatever reason the flame is extinguished. If the flames are blown out by wind, food spills, or in any other way, the gas flow will be cut off by this thermocouple.
When you notice that the burner is off, wait for a while and then try to turn it on again. If the gas stove flame does not light after turning and holding the screw, it means that the thermocouple wire has a problem and you must change the thermocouple wires to solve this problem. Of course, it should be noted that it is best to seek help from an expert in the field to replace a gas convection double burner.
2. Gas flame screw failure
Another part that can cause a gas stove to shut off is a damaged screw or gas stove sizing. With failure in this part, you cannot control the amount of flame, and because of this, the flame is either too high or too low to be extinguished. To fix such a problem, you should check the following:
1. Excessive slack in the shaft
The shaft is used to control the flame, and if it is not properly located and becomes loose, it cannot control the flow of gas to regulate the flame; Therefore, it increases or extinguishes the flame.
2. Shuttle damage
The spool is one of the parts that cooperates with the thermocouple and is used to shut off the gas flow when the flames go out for any reason. Now, if there is a problem in this section, it means that control of the gas burner is lost on the amount of gas passing through, and we can no longer control the flame. As a result of this incident either there were many flames or the gas burner went out; For this reason, this part must be replaced.
3. Screw jamming during rotation
The reason why the gas stove flame does not turn on may be that the screw is stuck in the rotating position. This can cause the screw to stop rising or turn off, so fix it to prevent the burner from closing.
Note: It should be noted that to solve any of the problems mentioned, you must contact a repair technician who specializes in this field.
Essence of the topic
The methods by which you can solve the problem of gas stove not turning on are mentioned in this article. Of course, it must be said that almost all methods are best left to a professional repairman in the field. If you have checked the mentioned methods and still cannot find the reason why the gas stove flame does not turn on and fix the problem, you must diagnose the gas stove and complete the service.
